33
7.3.7 Relay port defi nition
When the
HDMI Control Basic 4K60
initiates SYSTEM ON, the Relay 1 port will
perform the following actions:
1.
The NO connection closes, and NC connection opens.
2.
When the dwell time is over, the NO connection opens, and NC connection
closes.
When the
HDMI Control Basic 4K60
initiates SYSTEM OFF, the Relay 2 port will
perform the following actions:
1.
The NO connection closes, and NC connection opens.
2.
When the dwell time is over, the NO connection opens, and NC connection
closes.
7.3.8 System commands
Command
Function
Feedback
RST.
Reset to factory default.
Factory Default!
SCALERON.
Enable 4K to 1080P down-scaling function.
OPEN DOWN SCALER FUNCTION!
SCALEROFF.
Disable 4K to 1080P down-scaling function.
CLOSE DOWN SCALER FUNCTION!
GDOWNSCALER.
Report down-scaling status.
DOWN SCALER FUNCTION IS
OPEN!
DOWN SCALER FUNCTION IS
CLOSE!
GEDIDMODE.
Report EDID settings (DIP switch)
EDID:PASS THROUGH
GHDCPMODE.
Report HDCP settings (DIP switch)
HDCP:PASSIVE!
GALLINFO.
Report all device information.
Unit: Kindermann HDMI Control
Basic 4K60
FW: V1.0.0
…
8. Firmware upgrade
Please follow the steps below to upgrade the fi rmware by the USB FW port on the front panel:
1.
Prepare the latest upgrade fi le (.bin) and rename it as “FW_MERG.bin”.
2.
Connect the
HDMI Control Basic 4K60
to a PC via USB cable and power it on. The PC will automati-
cally detect a U-disk named of “BOOTDISK”.
3.
Open the U-disk, a fi le named of “READY.TXT” will be shown.
4. Copy the upgrade fi le (.bin) to “BOOTDISK”
5.
Refresh the disk to check whether “READY.TXT” has changed to “SUCCESS.TXT” automatically, if
yes, the fi rmware upgrade was successfully. Otherwise please check the above description and
repeat.
6.
Remove the USB cable, and then reboot the controller.
