Kindcomfort KIT 01, Инструкция по эксплуатации

Страница: 16 / 20

30 31
the vehicle anchor point. You will hear a “ click ”
when properly fastened (4.3, 4.4, 4.5 & 4.6).
5. tighten the lap belt and diagonal shoulder belt,
then place the red safety clip (n) on the diagonal
shoulder belt tongue as near to the vehicle
anchor point as possible without touching it!
(4.7, 4.8, 4.9 & 4.10).
Make sure the vehicle’s safety belt is not twisted,
also check that the seat cover does not impede the
movement of the vehicle’s safety belt or prevent the
installation of the seat in any way. to release your
child unbuckle the vehicle safety belt as described in
the instructions.
ensure that the belt has no slack.
5. adJustinG CHild seat.
Fastening & unfastening the harness
1. Join the 2 buckle metal connectors, pass both
connectors through the slot in the upper part of
the buckle until you hear a “ click ” (5.1).
2. to unfasten the harness press the red button on
the buckle downwards (5.2).
loosening the harness
3. release the buckle by sliding the red (F) button
downwards and at the same time pulling out the
harness (5.3).
tightening the harness
4. pull the harness straps up to remove the slack
from the lap section of the harness, then pull the
harness regulating strap until the harness is fully
stretched (5.4).
5. the harness should be as tight as possible
without causing discomfort to your child.
6. Make sure the lap section of the harness is
positioned as low as possible, surrounding your
child’s hips and not his stomach.
7. a harness that is not properly tightened can be
dangerous. check the harness adjustment and
tighten whenever you put your child in the child
safety seat.
Changing the harness height
8. place the child on the seat (5.5).
9. check the height of the shoulder straps. For
correct position, the shoulders straps must be
thread through the slots in the cover and seat
shell that are closest to the top of your child´s
shoulders (5.6).
10. adjust the height of the harness, by pressing
the harness adjustment button and pulling the
harness straps (C) towards you to loosen them
(5.2).
11. then, unhook the harness connector straps (l)
at the back of the seat and pull the loose strap
towards the front of the seat (5.7).
12. insert the harness strap into the appropriate slot
(J) that best fits the child’s height (5.8 & 5.9).
13. reinsert the harness straps in the harness
connector (l) on the back of the seat (5.10).