Laser line (Fig. 17 and 18)
1.
Place a workpiece on the table.
2.
Turn the laser switch (1) to the ON position.
3.
Lower the drill bit to meet the workpiece (2).
The two laser lines should cross where the drill
meets the workpiece.
4.
If the laser needs to be adjusted:
a. Using a 3 mm hex key, turn the laser
adjustment set screws (3) counter-clockwise.
b. Rotate the laser light housing (4) until the two
laser lines intersect where the drill meets the
workpiece. DO NOT stare directly at the laser
lines.
5.
Re-tighten the adjustment set screws (3).
VI. Assembly and adjustments ... continued
16
WARNING:
DO NOT STARE DIRECTLY AT THE LASER BEAM! A HAZARD MAY EXIST
IF YOU DELIBERATELY STARE INTO THE BEAM, PLEASE OBSERVE ALL SAFETY
RULES: THE LASER SHALL BE USED AND MAINTAINED IN ACCORDANCE WITH THE
MANUFACTURER'S INSTRUCTIONS:
•
NEVER AIM THE BEAM AT ANY PERSON OR AN OBJECT OTHER THAN THE
WORKPIECE.
•
DO NOT PROJECT THE LASER BEAM INTO THE EYES OF OTHERS.
•
ALWAYS ENSURE THE LASER BEAM IS AIMED AT A WORKPIECE THAT DOES NOT
POSSESS REFLECTIVE SURFACES AS THE LASER BEAM COULD BE PROJECTED
INTO YOUR EYES OR THE EYES OF OTHERS.
Fig. 17
3
1
4
2
Fig. 18
