ADJUSTMENTS
Table adjustments
To raise or lower the table (Fig. 12)
1.
Loosen the support lock handle (1) and turn
the crank handle (2) until the table is at the
desired height.
2.
Tighten the table lock before drilling.
To rotate the table (Fig. 12)
1.
Loosen the support lock handle (1) and turn
the table around the column to the desired
position.
Note: The rack should rotate around the
column with the table support bracket. If the
rack binds and will not rotate, slightly loosen
the set screw in the rack collar.
2.
Tighten the support lock before drilling.
To tilt the table (Fig. 13)
1.
Loosen the bevel lock bolt (1) with the table
adjustment wrench provided, or with a
suitable socket wrench.
2.
Tilt the table to the desired angle, using the
bevel scale (2) as a basic guide.
3.
Re-tighten the bevel lock bolt.
4.
To return the table to its original horizontal
position, loosen the bevel lock bolt (1).
5.
Realign the table to the 0° setting on the
bevel scale (2).
6.
Tighten the bevel lock bolt with the wrench.
To install the table extension (Fig. 14)
1.
Insert the two rods (1) of the table extension
into the two channels (2) at the side of
the table.
2.
Place a wing knob (3) in the opening on the
bottom of each channel and tighten to secure
the extension to the table.
VI. Assembly and adjustments ... continued
14
Fig. 12
1
2
Fig. 13
Fig. 14
1
2
3
2
1
