Kinco HP043-20DT, Руководство пользователя

Страница: 11 / 53

Kinco-HP
User Manual
11
phase).HSC2 and HSC3 can support up to 20KHz for single phase and 10 KHz for AB phase.
CPU Single phase AB phase
HSC0 and HSC1 HSC2 and HSC3 HSC0 and HSC1 HSC2 and HSC3
HP043-20DT 50K 20K 50K 10K
HMI-PLC provides 3 high speed pulse outputs(Q0.0,Q0.1 and Q0.4).All support PTO
and PWM.Q0.0 and Q0.1 support up to 50KHz (The resistor of load should be less than
3KΩ),Q0.4 supports up to 10KHz.
CPU Q0.0 Q0.1 Q0.4
HP043-20DT 50K 50K 10K
2.1.5 Edge Interrupts
I0.0-I0.3 in CPU support edge interrupt function, it can execute interrupt by rising edge and
falling edge of input signal. By using this function, it can capture the rising edge and falling
edge of input signal quickly. For some input signal whose pulse width is less than the CPU
scan time, it can respond quickly.
2.1.6 Data Retentive and Data Backup
Data retentive means the data in RAM can retain after power failure.CPU provides a
lithium battery (Replaceable but un-rechargeable) for data retentive. When CPU loses power,
the data in the RAM will be maintained by the lithium battery, and the retentive ranges will be
left unchanged at next power on.Through
[Hardware]
configuration in KincoBuilder, user can
select the type of data retentive (Such as V,C area) and the range. The life of battery is 5 years
and the retaining duration is 3 years at normal temperature.
Data backup is that CPU provides an E
2
PROM to store data permanently. At power on, the
CPU will restore the data from E 2 PROM into RAM to execute.
Note: Because E 2 PROM has a writing limit of 1 million times, users should avoid to write data