Kimo MP 200 G, Руководство пользователя

Страница: 8 / 16

Probe menu
Wire probes and modules with Smart-plus system are automatically recognized from first connection.
The ''
Probe '' menu only appears when probes or module are connected. This menu allows to view probe
information plugged to C2, Module, C1 or wireless connections .
(See « Connections » p 6 for more information about connections).
Available information are :
•
Sensor type, Serial number, Date of last calibration or adjustement, Probes Status (enabled ou disabled).
On enabled mode, the probe is connected, the measurement is carried out and the value is displayed.
On disabled mode, the probe is connected, the measurement is not carried out and the value is not
displayed.
Pressure
Access Pressure function by means of key. With Pressure function, you can
access to following sub-functions
- Hold - see Air velocity
- Config. (Configuration) - see Air velocity
- Params (Parameters) - see Air velocity
- Avg. (Average) - see Air velocity
- Rec (Recording) - see Air velocity
8
IV – Menus
Infos Measure
Probe display
Params
Pressure
AIRFLOW
Access Airflow function by means of key. With Airflow function, you can access to following sub-functions
- Hold – see Air velocity
- Area
- Config. (Configuration) - see Air velocity
- Params (Parameters) - see Air velocity
- Avg. (Average) - see Air velocity
-
Rec
(Recording) - see Air velocity
To select vent
Type
press
OK
or

.
Select Lx W or Diam or K factor with arrow buttons  and  . Confirm with OK . If K factor is
selected, you must enter value. You can choose a K factor already registered by selecting with 
and  . Confirm with OK . This factor can be modified by selecting with  and  , then confirm
with OK or  . Select Modify with OK or  . Enter factor by means of arrow keys  and  .
Confirm with OK or  .
•
Duct type
Area
Airflow
Functions
Rec. Config
Params
Veloci.
AutoZ
Airflow
Hold
Probe
Avg.
Alarms
PRESSURE display
AIRFLOW display
Rec. Config
Params Area
AutoZ
Press
Hold
Probe
Alarms
Veloci.
Avg.
•
Sizes
Press  or OK to enter into sizes sub function. You can choose an air vent already registered by selecting it with arrow keys  and  .
Confirm with OK or  . This air vent can be modified by selecting it with arrows keys  and  , then Confirm with OK or  . Select Modify
with OK or  . Enter sizes by means of arrow keys  and  . Confirm with OK or  .
This sub-function allows to compensate for any long-term drifts of the sensing element by a manual adjustment of the zero.
For the ±500 Pa measurement module, self-calibration is performed by the solenoid valve. Once pressing
Autoz key, the zero is readjusted.
This function can also be automatically performed by using the solenoid valve function.
For others measurement modules, self-calibration is performed by disconnecting the two pressure inlets of the sensor, then by pressing
Autoz
key.
AutoZ
actoolsupply.com
actoolsupply.com