6
22. Pull the battery insulator strip out from
the back of the battery compartment
(see figure 21).
23. Install the battery compartment onto the
back or side wall under the countertop.
Install it with the cable coming out the
bottom and no further than 32” from the
motor module (see figure 22).
24. Install the power cable plug into the
power receptacle on the motor module
(see figure 23).
Note: The red and yellow lights on the
bottom of the soap discharge head should
begin to blink, indicating proper installation.
If the lights do not flash, refer to the
Troubleshooting Guide.
Note: The battery compartment comes
with 4 D cell batteries installed. To change
batteries, insert the key into the top of the
battery compartment (see figure 24A), then
grasp the cover and pull it out (see figure
24B). The batteries are in the cover. Push the
cover back into place after new batteries are
loaded (see figure 25).
Fig. 24
Fig. 24
Fig. 23
Fig. 21
Fig. 24A
Fig. 24B
Fig. 25
Fig. 22
