Glass Tables
Tools Required
Package Contents
Installation
Note:
It is recommended that three (3) persons be used for
assembling glass table units.
1. Place the worksurface frame/rails on a clean, soft surface,
underside facing up. Align the leg assembly to the eight
predrilled holes of rails and fasten. (Figure A).
2. Flip unit right side up. Cut six strips of double-sided
adhesive tape and place them along the edges of rails as
shown.
DO NOT
remove the film backer to expose the
adhesive at this time. (Figure B).
Note:
The rails and underside of glass top
MUST
be clean,
dry, and free of any dirt or residue to assure adequate adhesion.
3. Carefully set glass worksurface on leg assembly. Center up
all four sides of top so that the outside edge of glass is flush
with outside edge of legs. (Figure C).
Assembly Instructions
Fluent
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 2205352
Revision A-09
Page 1 of 2
Figure A
Figure B
Tape
Doudle Sided
Adhesive Tape
M4 Machine Screw
Scissors
Screw Gun
#2 Phillips Head Bit
Tape
(6" pieces
on sides)
Tape
Tape
(Full length
on ends)
Figure C
Flush
Leg
Assembly
Glass Top
