Copyright © Changsha KILOVIEW Electronics CO., LTD. All rights reserved
D300
·
User Manual
13
The parameters of the video source are defined as follows:
6.2.2
Add SRT source
Add a SRT source in the page of video decoder by "Media"–"Add Source"–"SRT".
The parameters are defined as follows:
Name: You can name it freely, supporting letters and numbers combination;
Connection Mode: Caller, Listener, Rendezvous;
URL address: When using the CALLER mode, the URL address format is: srt:// the peer public IP
address: port; when using the LISTENER mode, the URL address is: srt://:port
Address: Set IP address of the receiving port;
Port: Configure a listening port which should be consistent with the sending port;
Latency: please set it according to the configuration of the video encode and the final delay will be the
larger one between encoder and decoder. Default is 125ms;
Name
Video source name, can be set at will, support mixed Chinese and English
URL Address
Support RTSP, RTMP, RTMPS, UDP, HTTP and other protocols, decoder can
automatically identify the URL address. After entering the URL address, if some
advanced parameters are configured, the dialog box will automatically pop up to
configure the corresponding parameters. You can also click on the protocol options on
the page to set the parameters directly.
Transmission Mode Choose TCP or UDP
User/Password
Configuration is based on whether or not the video source is authenticated by the user.
Normally, no configuration is required.
Decoding buffer and
delay
For a variety of different application scenarios and networks, to balance of delay and
fluency of the decoding, the device provides a variety of buffering strategies for users
to choose.
Zero buffer, 50ms, 120ms, 200ms, 500ms, 1s are optional. Users can
choose on actual network conditions, good network with lower latency, and
bad network with higher latency.
