Kikusui PLZ1004WH, Руководство пользователя

Страница: 11 / 158

PLZ-4WH
11
10
Rotary knob Used to make selections and change settings. p. 30
11
CURSOR
Up, down, left, and right keys. –
INS key Inserts a step (sequence editing). –
DEL key Deletes a step (sequence editing). –
PREV key Returns to the previous screen (menu settings). –
NEXT key Switches to the next screen (menu settings). –
12
LOCAL key Used to switch to local mode from remote mode. p. 46
LOCK key Used to set the key lock. p. 45
13
ENTER key Used to confirm the input (menu settings). –
ABC key Used to save settings to the preset memory. p. 49
14
SHIFT key Shift key. p. 30
15
RECALL key Used to recall the setup memory. p. 52
STORE key Used to save the setup memory. p. 51
16
C key Used to access preset memory C. p. 49
PAUSE key Pauses the PLZ-4WH during sequence operation. p. 81
17
B key Used to access preset memory B. p. 49
RUN/STOP key Stops the PLZ-4WH during sequence operation. p. 81
18
A key Used to access preset memory A. p. 49
EDIT key Used to edit sequences. p. 61
19
LEVEL key Used to set the switching level to a current or conductance value. p. 40
% key Used to set the switching level to a percentage.
20
FREQ/DUTY key Used to set the switching frequency and duty ratio. p. 41
Th/TL key Used to set the switching time.
21
SW ON key Turns the switching function on and off. p. 41
22
LOAD key Turns the load on and off. p. 31
23
MODE key Switches the operation mode. p. 33
+CV key Adds CV mode (constant voltage) to CC or CR mode. p. 35 , p. 37
24
SET/VSET key Used to set the fundamental settings (current, conductance, voltage, or power). –
MENU key Displays the menu setup screen. p. 58
25
RANGE key Switches between the appropriate ranges (current, conductance, voltage, or power)
for the current operation mode. –
V RANGE key Switches between voltage ranges. –
26
SLEW RATE key Used to set the slew rate. p. 42
SHORT key Turns the short function on and off. p. 44
27
OPP/OCP key Used to set the power at which overpower protection (OPP) is activated or the current
at which overcurrent protection (OCP) is activated. p. 54
UVP key Used to set the voltage at which undervoltage protection (UVP) is activated. p. 55
28
Current Range Displays the current range. –
29
Voltage range Displays the voltage range. –
30
Lock icon Appears when the key lock is enabled. p. 45
31
Remote icon Appears during remote control. –
32
COARSE/FINE icon Indicates whether the rotary knob is set to coarse or fine adjustment. p. 30
33
mA/A Displays the measured current value. –
V Displays the measured voltage value. –
W Displays the measured power value. –
34
Operation status Indicates the operation mode being used or the status.
In CC+CV mode, CC or CV is displayed.
In CR+CV mode, CR or CV is displayed. p. 33
35
Elapsed time Displays the amount of time that has elapsed since the load was turned on. p. 57
36
Setting Displays the fundamental setting (current, voltage, power, or conductance). –
37
Short icon Appears when the short function is being used. p. 44
38
Multi display Displays settings other than the fundamental setting.
When a value can be set, it is underlined, and the item name is highlighted. –
39
Set operation mode Displays the set operation mode. –
No. Name Function
See