12
PCR-LE2 series
Handling the output terminal cover
When shipped from the factory, the terminal cover is attached using
the left holes so that the OUTPUT terminals are not exposed.
If you are not using the OUTPUT terminal block, attach the terminal
cover as figure below.
When the terminal cover is attached using the left holes,
the output terminals are not exposed
Use the left holes to attach
the terminal cover.
When the load cable you use is 38 mm
2
(AWG1) or more, use the
right holes to attach the terminal cover.
Use the right holes to attach
the terminal cover.
When the load cable you use is 60 mm
2
(AWG0/2) or less, flip the
terminal cover upside down and attach it.
Single-phase output
1
Check that the POWER switch is turned off.
2
Check that the breaker of the switchboard is off.
3
Unfasten the screws (two locations) of the OUTPUT
1P2W terminal block cover, and remove the cover.
OUTPUT 1P2W terminal block
4
Securely connect the load cables to the OUTPUT
1P2W terminal block.
If the load has a ground (GND) terminal, be sure to connect
it to the G terminal of the PCR27000LE2 OUTPUT 1P2W
terminal block. Be sure to use a wire whose diameter is
greater than or equal to the diameter of the wires used to
connect the load.
G
N
L
M8
5
Fasten the cover that you removed in step 3 with the
screws (two locations).
Connecting the Load (Cont.)
Connecting wires to the PCR12000LE2, PCR18000LE2, or PCR27000LE2
