13
“Movement is life!”
C
Figure 4: Leg Length Adjustment
Figure 3: Back Height Adjustment
B. BACK HEIGHT ADJUSTMENT
1. Loosen the bolts [A] on the back cane clamps (4) using 7/16” wrench.
2. Loosen the laterals and other items attached to the back as necessary.
3. Slide the back to the desired position.
4. Tighten and check all items loosened in steps 1-3.
NOTE:
For back heights less than 22.5”, back plates will have only the upper
clamps attached. Clamps for lower attachment point are installed on back
canes, but not attached to back plate. If back height needs to be adjusted
above 22.5”, it is necessary to attach clamps to lower crossbar of back plate.
Back height is measured from surface of seat to top of back plate.
C. LEG LENGTH ADJUSTMENT
1. Remove the fabric calf protector to expose the leg length adjustment
bolts.
2. Use a 5/32” Allen wrench to loosen the 2 adjustment screws [A] on
each side.
3. Adjust the leg length to the desired position. Note that leg length must
be adjusted in 1/2” increments. Bolts must engage holes in footrest
extensions.
4. Tighten the screws [A].
5. Always install the calf protector to cover the adjustment bolts.
D. ADJUSTING THE POSITION OF THE ADDUCTORS & LATERAL SUPPORTS
1. The position of the lateral support plate can be adjusted using a 5/32” hex driver (
Fig. 5
). Loosen bolts and adjust to
desired position. Tighten bolts.
2. Hip width can be adjusted by adding or removing layers of 1/4” foam from adductor covers (
Fig. 6
).
Figure 5: Lateral Plate adjustment
Figure 6: Hip Width Adjustment
A
WARNING: If back height is adjusted above
22.5” without lower clamps installed, instability
and/or breakage will occur.
