12
“Movement is life!”
V. SET-UP & ADJUSTMENT
Tools Required:
5/32” Hex Wrench
7/16” Nut Driver
3/4” End Wrench (Active Tension Only)
1-1/8” End Wrench (Adj. Position Axle Only)
A
B
C
Figure 1: Seat Depth Adjustment
D
E
A. SEAT DEPTH ADJUSTMENT
1. Remove the seat cushion.
2. Use a 5/32” hex wrench to loosen the
bolts [A] on the left and right tubes.
3. Loosen any accessories that prevent the
seat pan from sliding.
4. Push or pull on the front of the seat,
evenly on both sides, until the seat
reaches the desired depth.
5. Tighten the hex screws [A] and any
accessories loosened in step 3.
6. When the seat depth is changed, the glide
blocks [B] must be adjusted for proper
weight distribution and active motion.
Follow these steps carefully:
a. Set the hip angle adjustment to
position that best accommodates the
child. This will allow for accurate
positioning of the glide blocks.
b. Using a 5/32” hex wrench, loosen the adjustment bolts [C] on the left and right glide blocks.
c. Position the glide blocks so that the center of the notch on the left side of the seat plate [D] is in line vertically
with the circular mark on the glide block [E] (
Fig. 2
).
d. Tighten the bolts [C] and verify that the glide blocks [B] cannot move. Cycle active motion to verify smooth op-
eration. If Seat Plate falls behind glide blocks, glide blocks need to be moved inward.
e. Reposition hip angle as needed.
WARNING: Improper adjustment of the glide block can create a pinch point for
the child. Always adjust the glide block as indicated in the above instructions. Im-
proper adjustment of the glide blocks voids warranty.
