![background image](http://html1.mh-extra.com/html/kidde/21027311/21027311_user-manual_1965227017.webp)
17
The alarm is now activated! After installation / activation, test your alarm as described in Operation and Testing section.
WArnIng: fAIlUre to ProPerly InStAll And ACtIVAte thIS AlArM WIll PreVent ProPer
oPerAtIon of thIS AlArM And WIll PreVent ItS reSPonSe to fIre hAzArdS.
9.2 Adding Another Wireless Device to an Existing
Wireless Alarm Network
For various reasons, you might want to add additional units to your existing wireless alarm network. Modifying your
existing wireless alarm network is easy and user-friendly.
A.
reMoVe the neW deVICe froM ItS PACkAgIng.
b.
PoWer UP neW deVICe
Locate the red wheel on the back of the device being added. Turn the red
wheel to the “ON” position using the white activation tool included in the
Quick Start Guide or a standard screwdriver.
•
Once powered, the light ring will glow red.
C. PICk one InStAlled deVICe
Press and hold the button on ONE INSTALLED device on your network until
you hear two beeps. Release button. You will hear “Searching for other
devices.”
•
Light will pulse green and device will sound a continuous “Sonar” ping
until step E is completed.
Figure 9.2-B
ON
PERMANENTLY
DISABLE and
DISCHARGE
alarm
Break
tab
SMOKE AL
ARM: 3 long beeps, repeating
CO ALARM: 4 quick b
eeps, repeating
STANDBY: Green LED blink ev
ery 60s
FAULT: Amber LED blink with chir
p every 30s
LOW BATTERY: Amber LED blink ev
ery 5s, chirp every 60s
END OF UNIT LIFE:
Amber LED blink every 5s, chirp twic
e every 30s
Push button to test weekly.
See user guide for more informa
tion
USE ACTIVATION
TOOL OR SCREWDRIVER
Figure 9.2-C
Device Being Added
“Searching for
other devices.”
Installed Device