OPERATING INSTRUCTIONS
Manual Override Mode:
8
CARE AND MAINTENANCE
• Always be certain electric current is turned off before cleaning this item.
• Use a soft, moist cloth with mild non-abrasive soap to clean fixture. Never use glass cleaner on
fixture, as it will damage the metal finish.
At night, you may manually override the Auto Mode on the sensor to force the light to stay on until
dawn. To switch the operation between Manual and Auto Mode, toggle the wall switch controlling the
light off for 2 seconds and then back on.
• The glass shade may be washed in a towel-lined sink with warm water and mild soap. wash shade
in an automatic dishwasher.
• Clean the sensor lens with soft cloth every 1 to 2 months to maintain sensitivity.
TROUBLESHOOTING
.
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Fixture does not
light.
1. Fixture may be wired incorrectly.
2. Worn or broken bulb.
3. Fixture is set to Auto Mode.
1. Check wiring.
2. Replace bulb.
3. Cover the sensor with your palm to
verify the light level is not too high.
Fixture stays on
continuously.
1. Fixture is not set to Auto Mode.
2. There is motion in the detection
area.
3. Shut-Off settings are incorrect.
1.
power off and on.
2. Make sure there is no motion in the
detection area.
3. Adjust the Time knob
counterclockwise to reduce the
Shut-Off delay time.
Fixture light blinks
on and off.
1. A heat source is too close to light.
2. Sensitivity is set too high.
1. Make sure the light is not mounted
near any heat source.
2. Reduce the sensitivity to avoid the
undesired triggering by passing
