30
Kice Industries, Inc.
012420 / FLT-M02-0004
WARNING:
Disconnect power before touching any component part!
WARNING:
Vent area may differ between explosion panel manufacturers. The required vent
area should be verified when replacing panels. Contact Kice Industries for explosion vent
replacement and information.
7. If fuse blows, observe at which output light the malfunction occurs and recheck that output circuit
for shorted condition.
8. If a valve stays open after it is de-energized, replace the valve.
a. If a valve stays energized, replace the timer board.
b. If a valve does not operate when its output light is on, replace the wiring or the solenoid valve.
Some Things NOT TO DO
1. DO NOT mount controls in high vibration areas without shock mounts.
2. DO NOT mount controls in areas of high dust or corrosive atmospheres without a protective
enclosure.
3. DO NOT use a converter or inverter for the power source.
4. DO NOT mount the control in a high transient voltage area without an isolation transformer.
5. DO NOT leave the control box door open.
6. DO NOT allow a local repair shop to repair the controller. For service info call Kice.
Replacement Parts
It is recommended that only Kice supplied replacement parts be used. Kice filter parts are built to be
fully compatible with the original filter, using specific alloys and tolerances. These parts carry a
standard Kice warranty.
When ordering replacement parts, specify the part name, the Kice filter serial number, the filter model,
and the filter size, series (VM, VS, or VR) and number of filter bags. Most of this information is on the
metal nameplate attached to the filter housing next to the access door.
When ordering solenoids for ASCO solenoid operators or valves, order the number stamped on the
solenoid. Also, specify voltage and frequency.
When ordering a replacement solid-state electronic controller, refer to the Filter Maintenance and
Service section, or by specifying the total number of outputs on the controller you are replacing.
Troubleshooting Continued