Genuine Accessories
N
O
T
E
1. Hold the mirror harness against the headliner and wrap one (1) foam
tape around the harness where it meets the corner of the A-pillar.
2. Wrap one (1) foam tape on the harness between the two previously
installed foam tapes.
3. Tuck the harness with the wrapped foam tape into the headliner
across from the mirror to the A-pillar.
24
N
O
T
E
1. Route mirror harness down the A-pillar into the dash, toward engine
side of fuse panel.
NOTE: Ensure wire harness is routed away from the side curtain
airbag, and sunroof drain tube, if equipped.
2. Secure mirror harness near the vehicle harness clips, and above the
electrical connector at the bottom of the A-pillar, with four (4) wire ties.
3. Trim the excess wire tie length.
CAUTION: Use caution when working with the headliner to prevent
creases or damage.
CAUTION: DO NOT secure to airbag inflator.
DO NOT secure to sunroof drain tube, if equipped.
Tape Measure
N
O
T
E
1. Pull mirror harness wires apart approximately 300mm (12in), as shown.
23
21
Tape Measure & Nylon Panel Removal Tool
22
Side Cutters
CAUTION: Ensure harness does not catch on vehicle component, or is
damaged during the routing.
CAUTION: DO NOT use a razor blade or any other sharp tool to
separate the wires. Ensure wire is not damaged during
separation.
N
O
T
E
1. Route mirror harness through dash, on the engine-side of the
junction block.
2. Route mirror harness below the junction block, pulling the 3 terminals
toward the driver's seat.
Foam Tape
*550-0670-000*
550-0670-000 Rev. 004
Revision Date
11/23/2015
Page 9 of 17
