Genuine Accessories
27
Pliers
28
N
O
T
E
1. Locate Connector C (38 pin connector) on the front side of the
junction block (furthest side from the engine).
N
O
T
E
1. Locate
Pin 23 (BROWN wire)
of Connector C.
25
26
N
O
T
E
1. Attach one (1) T-tap to the wire at Pin 23 (Brown wire).
Use Pliers to snap the T-tap together.
Refer to the Electrical Connection Procedure at the beginning of the
instructions for more details.
N
O
T
E
1. Insert male spade terminal of the mirror harness (Black w/ White wire)
into the T-tap connector (Brown wire), for switched ignition power.
Refer to the Electrical Connection Procedure at the beginning of the
instructions for more details.
CAUTION: Ensure the correct wire is identified.
NOTE: Factory wire colors are subject to change at any time.
Refer to the pin number to correctly identify the circuit.
CAUTION: Ensure that the wire is in the slot of the T-tap, and that both
halves of the T-tap are snapped together properly.
CAUTION: Ensure the male spade connector is fully inserted into the wire
tape. Check that the spade did not "miss" the female slot. Check that the
males spade is not visible on either side of the female connector.
Connector C
Pin 23
Brown
Pin 20
Pin 19
T-Tap on
Pin23
Brown
Black w/
White wire
connected
*550-0670-000*
550-0670-000 Rev. 004
Revision Date
11/23/2015
Page 10 of 17
