Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
WorkUp
®
Adjustable Table - Model CR
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Wire Trough Installation
Note:
The wire trough is an
accessory that must be ordered
separately.
1. An optional wire trough may
mount to the underside of the
tabletop, centered over the
tabletop supports of any depth
table, as illustrated in Detail D.
If the tabletop depth is 36”, the
wire trough can mount behind
the cross-tube assembly as
illustrated in Detail E.
2. Align the wire trough mounting
holes to the appropriate holes in
the tabletop. Using six #10 x
5
/
8
”
pan head screws, secure the
wire trough to the tabletop as
illustrated (Figure 5, Details D
or E).
tabletop
Figure 5
wire
trough
#10 x / ”
pan head
screw
5
8
tabletop
support
tabletop
wire
trough
cross-tube
assembly
Detail D - 24”, 30” or 36” Centered Wire Trough
wire
trough
tabletop
cross-tube
assembly
Detail E - Behind Cross-Tube Assembly
36” Tabletop Depth
1330 Bellevue Street • P.O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
© 2019 Krueger International, Inc. All Rights Reserved • Code KI-62449R7/KI/PDF/1019
Operating the Table
1. Carefully invert the table to its
upright position.
Caution:
The
table is very heavy. Two or more
people are required to turn the
table upright.
2. Adjust leveling glides to level the
table.
Note:
When adjusting the table
always be sure hands are clear
of any potential pinch areas
created by the table and adjacent
furniture.
3. The table can be adjusted to
the desired height by gently
pulling the crank handle out of
the stored position and cranking
clockwise to raise the table and
counterclockwise to lower the
table. Once the table is at the
desired height the handle can be
pushed in to the stored position.
