2
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
WorkUp
®
Adjustable Table - Model CR
Assembly Instructions
Tabletop Support to Columns
Assembly
Note:
Tabletop support wings are
not present on tabletop supports for
22”-24” deep tables as illustrated
in Details B & C. Tabletop support
wings are only present on tabletop
supports for 30”-36” deep tables as
illustrated in Figures 2 & 3.
1. With the foot/column assemblies
upright, place the connecting rod
into the hex shaped holes on the
inside of each column. At this time
be sure the other hex bushing in
each column is facing the same
direction. This direction will become
the front of the table. If the two
remaining hex bushings are facing
opposite directions, rotate one
foot/column assembly so the two
hex bushings are facing the same
direction (Figure 2 & Detail B).
Note:
Be careful not to rotate the hex
bushings on columns until the table
is assembled. Doing so will adjust
the columns to different heights.
2. Place the foot/column assembly
between the angle members of the
tabletop support and align the four
holes in one end of the support with
the four holes in the column
(Figure 2 & Detail B).
3. Attach the tabletop support using
four M8 x 35 mm screws, tightening
each screw one quarter turn at a time
in a diagonal pattern until all four
screws are tight (Figure 2,
Details A & B).
4. Attach the second foot/column in the
same manner (Figure 2 & Detail B).
Base-to-Tabletop Assembly
Note:
The tabletop is pre-drilled for
installation of all components.
1. To avoid scratching the tabletop
place it with the top side down on a
soft, protective surface.
2. Place the tabletop support with
columns on the drilled face of the
tabletop so the heads of the M8 bolts
set into the pockets milled in the
tabletop. The support should now be
flush with the tabletop (Figure 3 &
Detail C).
3. Move the tabletop support with
columns slightly to align the holes in
the tabletop with those in the support
(Figure 3 & Detail C).
4. Attach the tabletop support to the
tabletop using #12 x 1” tapping
screws in each available hole
(Figure 3 & Detail C).
Figure 2 - 30”-36” Deep Tables
tabletop support
(30”- 36” deep tables)
connecting
rod
hex
bushing
hex
bushing
foot/column
assembly
M8 x 35 mm
screws
tabletop
support wing
Figure 3 - 30”-36” Deep Tables
tabletop
tabletop
support
#12 x 1”
screw
tabletop
support wing
Detail B - 22”-24” Deep Tables
hex
bushing
foot/column
assembly
M8 x 35 mm
screws
tabletop support
(22” - 24”
deep tables)
Detail C - 22”-24” Deep Tables
#12 x 1”
screws
tabletop
support
tabletop
