How to use
WARNING:
1. When cleaning carpet, please use low foam cleaner and add appropriate anti-foaming agent mix
evenly, otherwise the air outlet will have the possibility of foam eject!
2. It is recommended that users immediately empty the sewage in the vacuum cleaner dust barrel
after using 2 buckets of cleaning fluid each time to prevent the liquid in the dust barrel from being
too high and causing the possibility of foam spraying out from the air outlet
3. In the cleaning mode, when there is no cleaning fluid in the Soap bucket, please add it in time. Do
not idle the water pump to prevent damage to the water pump.
4. When the dust barrel is full or the safety valve is blocked, the sound of the motor will obviously
become louder. At this time, the dust barrel should be shut down and emptied immediately
E. Operation of blower
WARNING:
always wear safety googles before using blower
WARNING:
keep by standers clear from blowing debris
WARNING:
wear a dust mask if blowing creates dust that might be inhaled.
1. Make sure the power cord is disconnected from the power supply(Fig 1)
2. Unscrew the inserted hose assembly from the suction port with a left-hand rotation. (Fig 2)
3. Insert the hose assembly into the air outlet at the back of the head and tighten it with the right hand
rotation. (Fig 3)
12
EN
11
EN
How to use
Troubleshooting
Storage cervice nozzle and multi brush
- Insert the cervice nozzle into the wheel seat.
- Insert the large water spray head into the wheel seat.
WARNING! to reduce the risk of electric shock-unplug before troubleshooting.
Symptom
Vacuum will
not operate
No power supply.
Corrective Action
Possible Causes
Check power supply cord, breakers,
fuses.
Barrel full.
Empty barrel.
Faulty power cord.
Unplug and check the power cord. If
damaged, have it repaired by a
professional.
No filter is installed, the filter is not
installed in place or the filter is
damaged
Re-install and check whether the filter
is installed in place. Replace the new
filter if any damage is found.
Dust comes out
from motor
cover.
There is a blockage in the nozzle or
hose or the barrel inlet or cartridge
filter blocked by fine dust
Check nozzle, hose and barrel inlets for
blockage. Take off the filter and clean it.
Or install new cartridge filter
Reduced
efficiency and
motor/speed
vibration.
Does not spray
cleaning fluid
Cleaning is not selected
Press the cleaning button on the panel
or remote control hose
The pipe line is not properly installed
Check whether the water pipe connection
is in place correctly and pay attention to
check whether the water pipe is knotted.
Use up the cleaning fluid in the
soap bucket
Reinsertion the cleaning fluid
High bubble cleaning fluid was used
Replace the low-bubble cleaning solution
and add defoaming agent according to
the ratio.
Foam coming
out of the
machine head
unit outlet
The battery in the remote control
hose runs out.
Replace the battery in the remote control
hose
Connection between remote control
hose and vacuum cleaner is
abnormal
Read the remote learning operation as
stated in manual.
Remote control
hose failure
F. Operation of accessories
4. Insert the power cord. (Fig 4)
5. Press the standby button. (Fig. 5)
6. Hold the remote control hose and press suction button, then let the outlet port aimed at the leaves and
so on. (Fig. 6)
