How to Use
5. Insert the power cord. (Fig 5)
6. Press the standby button and the indicator light on the panel will lights up. (Fig. 5)
7. Press the suction button on the top cover panel or remote control hose, then the machine will start to
work. Suction mode is divided into high and low levels, press the suction button to switch from high to
low level and press again to stop working. (Fig. 6 & 7)
8. When the water is absorbed to the maximum capacity, the safety valve operates, the suction will cut off.
(Fig 8)
9. Turn off the power, disconnect the power cord from the socket. (Fig 9)
10. Pour out the water. (Fig 10).
11. To ensure the best result of water absorption, please remove the water sponge and hand-wring- dry
after drainage. (Fig 10) (Fig 10)
12. Wash the water sponge with normal water, hand-wring dry after washing, then it can use again. (Fig 12)
10
EN
9
EN
How to use
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED ‘SAFETY PRECAUTION
INFORMATION’. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS
IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO; LIGHTER FLUID,
SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE
DUSTS INCLUDE BUT ARE NOT LIMITED TO; COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE
THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
9. Connect the large water spray head or small water spray head with aluminium extension tube, insert
the water inlet pipe into the connector of the aluminium extension tube. (Fig. 9)
10. Insert the power cord. (Fig 10)
11. Press the standby button and the indicator light on the panel will lights up. (Fig. 11)
12. Press the cleaning button on the top cover or remote control hose, the sprinkle head on the large water
spray head starts to spray water. If the suction button is pressed again, the machine will spray water and
absorb the dirty water after cleaning at the same time. After use, press the standby button to turn it off,
then unplug the power plug, empty the sewage in the barrel and clean it for backup. (Fig. 12)
D. Operation of carpet washer cleaning
1. Make sure the power cord is disconnected from the power supply
（
Fig 1
）
2. Cover the bottom cap basket with water sponge and make sure it cover the entire basket. (Fig 2)
3. Place the top cover on the dust barrel and lock it with both side of clips. (Fig 3)
4. Align the hose assembly port with the suction inlet port and insert it into right and tighten it. (Fig. 4)
5. Remove the Soap bucket from the pedestal, then unscrew the lid to the left, and fill it with a clean
mixture mixed in an appropriate proportion (Fig 5)
6. Insert one end of pipe (with elbow) into the water pump inlet joint on the top cover; Place the other
end of inlet pipe with the filter into the soap bucket, then tighten the lid to the right. (Fig 6)
7. Insert the aluminium extension tube into the remote control hose and connect the water inlet pipe into
the connector of the remote control hose. (Fig 7)
8. You may connect the aluminium extension tube to increase the operation radius. (Fig 8)
9
or
