ENGLISH
Chapter 4: Using the DVR
DVR User’s Manual
53
Note:
• Obtain these information from your network administrator or your Internet Service Provider (ISP).
• If you cannot use the either of the two default ports, 80 or 9000, the specified port may be occupied by other
programs or it is being blocked by your service provider. Enter other port number. In this case, you need to
add the port number after the IP address. For example, if you set the
HTTP Port
as 85, you need to enter the
IP address as “192.168.3.103:85”.
5
Enter other parameter settings (if applicable).
• If your network connection is
Static
, specify the static IP address, Subnet Mask, Gateway, and DNS 1/DNS 2 IP
addresses.
• If your network connection is
PPPoE
, enter the User Name and Password that you setup with your DSL service
provider. Then, specify the DNS 1/DNS 2 IP addresses.
Note:
The system supports two DNS server input options: DNS Server1 for main server and DNS Server2 for sub server.
Please contact your local ISP (Internet Service Provider) to obtain the correct DNS Server parameter.
6
To enable
Auto Port Forwarding (UPNP)
feature, select
Enable
.
Note:
Not all routers support the Auto Port Forwarding feature. If this function does not work, you must manually open
the ports in your router.
7
After all settings are complete, click
Apply
.
8
When data saving is complete, click
OK
.
4.4.2 Remote Stream Setup
The Remote Stream page allows you to enable or disable video output of a particular channel if the channel is being
viewed via remote access.
1
In preview mode, right-click on the mouse to display the Pop-up menu.
2
Select
Main Menu
>
NETWORK
, select the
Remote Stream
tab. The remote stream framerate settings are
displayed on a table.
3
Select the channel and adjust the corresponding settings such as
Video
,
FPS
, and
Quality
.
4
Check the
Audio
box to enable audio.
5
To copy the current settings to all channels or one specific channel. Click the arrow on
Copy
and
To
to select an
option and then click
Copy
.
