KFV SIEGENIA DRIVE IO module, Руководство по сборке

Страница: 4 / 24

SIEGENIA access control systems Assembly instructions
IO module/IO module smart
05.2020 4/24 H39.ELEKS010EN-00
1 Introduction
Please.read.these.instructions.carefully.before.you.
begin the assembly work. Follow the notes in Chapter 2
"Safety", in order to prevent personal injury or mal-
functions.
These.instructions.are.an.integral.part.of.the.IO.mod
-
ule/IO module smart and must be accessible to the
specialist.personnel.at.all.times.
1.1 Producer and service
KFV Karl Fliether GmbH & Co. KG
A company of the SIEGENIA GROUP
Siemensstraße 10
42551 Velbert
Tel.: +49 2051 278-0
Fax: +49 2051 278-167
E-mail: info@kfv.de
Please contact your contractual partner in case of com-
plaints.or.service.requirement.
1.2 Target group of this documentation
This.documentation.is.intended.for.use.by.special -
ists only. All work described in this document is to be
performed only by experienced professionals with
training.and.practice.in.the.assembly,.as.well.as.the.
commissioning and maintenance of electromechanical
components.
All work on a 230 V AC mains power supply may only
be.performed.by.a.qualified.electrician.
1.3 Intended use
• The IO module/IO module smart serves as an inter-
face for electromechanical locking and unlocking
systems (e. g. A-opener, GENIUS A and GENIUS B/
Panic).
• The IO module/IO module smart is intended for
indoor use (IP20) with a room temperature of 0°C to
45°C.and.is.either.installed.in.suitable.flush-mount -
ed boxes or surface mounted in approved branch
boxes.
• All.assembly.and.electrical.installation.work.must.be.
carried.out.according.to.our.assembly.instructions.
• Use the IO module/IO module smart only when it is
in.a.technically.sound.condition.
• Repair of the IO module/IO module smart is not
permissible. The IO module/IO module smart must
be replaced in case of faults.
1.4 Improper use
• The IO module smart must not be installed in a
metal casing, as this could lead to shielding of the
WIFI signal.
• The IO module/IO module smart must not be used
in event of air humidity > 80 %. The unit is not
approved for use in swimming pools and/or wet
rooms..The.air.must.not.be.subject.to.condensation.
• The IO module/IO module smart and its connected
electromechanical components must not be tam-
pered.with.and/or.modified.
1.5 Maintenance and service notes
Never use cleaning agents that are aggressive or con-
tain solvents. This could damage the surfaces of the
components.
1.6 Installation conditions and requirements
Local.building.laws.and.regulations.must.be.observed.
before.and.during.installation.
1.7 Dimensions
All measurements are given in mm.
1.8 Symbols used
The following icons are used in this document:
general warning symbol
useful.information.or.advice
Continue.reading.the.instructions.at.
the corresponding point