Multimeter Features
3
Keysight U1241C/U1242C User’s Guide
107
Reviewing Previously Recorded Data (View)
to review or erase the recorded
entries.
Performing event logs (triG)
Ensure that
is selected as the data logging option in the multimeter’s
Setup.
Event logs are used only with the following modes:
– TrigHold and AutoHold (
– MaxMin recording (
Event records are triggered by the measured signal satisfying a trigger condition
set by the measurement function used in the following modes:
NOTE
Auto power-off (APO) is disabled during the recording session.
Table 3-2
Event log trigger conditions
Mode
Trigger condition
The input signal value is recorded:
TrigHold
Each time
is pressed for > 1 second.
AutoHold
When the input signal changes more than the variation count.
MaxMin
When a new maximum (or minimum) value is recorded. The average and
present readings are not recorded in the Event log.
Hold
Log
Содержание U1241C
