2
Making Measurements
50
Keysight U1190A Series User’s Guide
Testing for Continuity
Set up your clamp meter to test for continuity as shown in
. Probe the
test points, and read the display.
Press
to switch between resistance measurement, or continuity test. See
to learn more.
Figure 2-10
Open continuity display
Figure 2-11
Closed continuity display
CAUTION
To avoid possible damage to your clamp meter or to the equipment under
test, disconnect the circuit power and discharge all high-voltage capacitors
before testing for continuity.
NOTE
Continuity is the presence of a complete path for current flow. The continuity
test features a beeper that sounds and a backlight that flashes as long as a
circuit is complete. The audible and visual alert allows you to perform quick
continuity tests without having to watch the display.
Содержание U1190A Series
