1
Introduction
20
Keysight U1190A Series User’s Guide
1 Open the battery cover.
Loosen the screw with a suitable Phillips screwdriver
and remove the battery cover as shown in
2 Insert the batteries.
Observe the proper battery polarity. The terminal ends of
each battery are indicated inside the battery compartment.
3 Close the battery cover.
Place the battery cover back in its original position
and tighten the screw.
Figure 1-1
Installing the batteries
The battery level indicator in the lower left-hand corner of the display indicates
the relative condition of the batteries.
describes the various battery
levels the indicator represents.
Содержание U1190A Series
