Measurement Setup Parameters
M9703B Hardware Extension of 89600 VSA Software
17
Center Frequency Range: The range depends on which model you are
using:
Model Option
Mode
Center Frequency Range
M9703B -SR1
Normal (non-interleaved)
0 - 1 GHz
-SR2
Normal (non-interleaved)
0 - 1.6 GHz
-SR1
Interleaved
0 - 1.4 GHz
-SR2
Interleaved
0 - 1.4 GHz
Frequency Counter: Not available.
Trigger settings can be accessed via the Input > Trigger menu:
Trigger Type
Level
Default
External
-5 V to +5 V
2V
Channel
must be set within Offset ± FSR
-
Magnitude
2
0 to 1.414 V
10 mV
The following trigger parameters are available:
Style: Free Run
1
, External, Magnitude
2
, and Channel
Slope: available for External, Magnitude and Channel
Level: available for External, Magnitude and Channel
Delay: available for External, Magnitude and Channel
Trigger Holdoff: not supported by the digitizer.
Soft Front Panel Control: The 'Disconnect' feature can be used to pause the VSA and
release its control of the digitizer. Then the digitizer can be used independently from
the VSA, for example, using the MD2 SFP application. Independent control must be
released before resuming VSA measurements. When returning to the VSA sofware
and starting or resuming a measurement, the VSA restores the digitizer state that
was set before being disconnected.
Hardware: Set up an Analyzer Configuration with the digitizer as the Logical
Instrument, as described in
89600 VSA Software Configuration (page 7)
.
1
On Segmented Capture mode the free run triggered is not supported. (Segmented
Capture feature may be accessed via the MeasSetup > Time menu)
2
-DDC option is required for Magnitude triggering.