Keysight M9130A, Руководство для стартапов

Страница: 45 / 50

Keysight PXI General Purpose Switch Modules Startup Guide 44
General Purpose Module Accessories
Disassembling the Terminal Block Clam Shells
1 Loosen the two screws indicated in Figure 17. These screws are captive to the
bottom half of the clam shell. Note: the other two screws are for the strain
relief.
2 Separate the two clam shell halves. Be careful not to lose the long screw locks
used to secure the terminal block to the PXI switch module.
3 To use the strain relief, loosen the two strain relief screws and lift up on the
strain relief bar. Refer to Figure 18.
4 Insert your cable under the strain relief bar and retighten the two strain relief
screws.
5 To reassemble the clamshell, make certain the screw locks are in place. Place
the calm shell halves together. Tighten the two clam shell screws.
Figure 17 Disassembling the Terminal Block Clam Shell
Figure 18 Using the Strain Relief Clamp
Screws for
Strain Relief
Loosen these
two captive
screws to
separate clam
shell halves
Wires go under
strain relief bar.
Do not over tighten
strain relief clamp.
Do not overtighten the strain relief screws. Possible damage to
the cable(s) may occur if overtightened. Use only sufficient
tension to secure the cable in place.