Keysight M9130A, Руководство для стартапов

Страница: 44 / 50

43 Keysight PXI General Purpose Switch Modules Startup Guide
General Purpose Module Accessories
Figure 16 below shows the assembly of the connector. Note that the screw locks
hold the assembly together.
1 Strip off 1/4” of insulation from each wire. Take care not to damage or remove
strands of wire, untwist or over twist wire strands, etc.
1 Solder your wires into the solder cup contacts and insert the contacts into the
contact insulator.
2 Thread the wires through the connector housing and slide the insulator into
the housing. Attach but do not tighten the cable strain relief.
3 Insert the screw locks into the assembly. Be careful to note the polarity and
how they will match the screw lock nuts on the module connector.
4 Insert the roll pins into the screw lock thumbscrews to secure them to the
screw locks.
5 Tighten the cable strain relief.
Although not required, we suggest you purchase the Positronic Industries
9099-0-0 Terminal Insertion Tool and the 9081-0-0 Terminal Removal Tool.
Voltages greater than 30 Vrms, 42Vpk or 60 Vdc present an
electric shock hazard. Disconnect all source voltages
before connecting or removing the source-to-modules I/O
connector or wiring the connector block. All field wiring
must be rated for the highest voltage applied to any single
channel.
Figure 16 Y1193A Assembly
Roll Pin
Roll Pin
Thumbscrews
Connector Pins
Screw Locks
Insulator
Housing
Washers
Cable Strain Relief