Keysight E8718A Radar Target Simulator User Guide
5
Operator safety information
Cables and connectors are considered inaccessible if a tool (e.g., screwdriver,
wrench, socket, etc.) or a key (equipment in a locked cabinet) is required to gain
access to a conductive surface connected to any cable conductor (High, Low, or
Guard).
Verify there are multiple and sufficient protective means (rated for the voltages
you are applying) to ensure the operator will NOT come into contact with any
energized conductor even if one of the protective means fails to work as intended.
For example, the inner side of a case, cabinet, door cover, or panel can be covered
with an insulating material as well as routing the test cables to the front panel
connectors of the module through a non-conductive, flexible conduit such as that
used in electrical power distribution.
The E8718A is equipped with laser module for device under test alignment
purpose. Do not stare at the laser while operating it. Switch off the laser when not
in use.
WARNING
Module connectors and test signal cables connected to them cannot be
operator-accessible.
WARNING
Ensure the equipment-under-test has adequate insulation between the
cable connections and any operator-accessible parts (doors, covers, panel
shields, cases, cabinets, etc.)
WARNING
In order to avoid eye damage, do not stare at the laser.
CAUTION
CLEAN WITH SLIGHTLY DAMPENED CLOTH
Clean the outside of the instrument with a soft, lint-free, slightly dampened
cloth. Do not use detergent, volatile liquids, or chemical solvents.
Содержание E8718A
Страница 1: ...Keysight E8718A Radar Target Simulator User Guide ...
Страница 12: ...12 Keysight E8718A Radar Target Simulator User Guide THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK ...
Страница 14: ...14 Keysight E8718A Radar Target Simulator User Guide THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK ...