Keysight Technologies U2941A, Руководство по эксплуатации

Страница: 27 / 33

Keysight U2941A Operating Guide 27
– Universal socket module
The provided pitch sizes (0.1 inch, 0.075 inch, and 0.05 inch) offer you the
flexibility to mount your DUT on the U2941A. You may either solder the DUT
directly or insert an IC holder on the universal socket module. Open the casing of
the socket module by removing the screws and use a wire to connect the DUT
lead or IC holder lead to the jumper pin which is inserted on the socket module.
The jumper pins connection at the bottom layer of the printed circuit board (PCB)
is shown in the Bottom view figure. The other end of the jumper pins at the top
layer of the PCB allows you to connect the terminals to the jumper pins using the
pin plug to miniature clip cables as shown in the Top view figure.
Top view Bottom view
Pin plug to
miniature clips
Jumper
pins
Universal socket module
Wires
DUT
NOTE
Do not use the universal socket module for low leakage current measurements
(<1 nA).