Keysight Technologies N8241A, Руководство пользователя

Страница: 89 / 125

90 Chapter 3
Theory of Operation
Multiple Module Synchronization
Multiple Module Synchronous Trigger Timing
Triggers are registered into the AWG using the SYNC clock. The SYNC clock is
nominally at the sample clock frequency divided by 8. However at lower sample
rates an internal variable modulus prescaler selects other binary divide ratios: 8, 4, 2,
and 1. Multiple AWG synchronization is only supported in the 625 MHz to 1.25
GHz frequency range. The input clock frequency ranges and prescaler divide ratios
are as specified in
“SYNC Clock Frequency Ranges” on page 91
.
It is necessary to insure that the correct timing relationships are achieved to
guarantee consistent synchronous trigger operation. The trigger input must occur
within a valid window with respect to the SYNC clock. The window is specified by
two times: Twin_low -- the minimum trigger delay after the prior SYNC clock edge;
and Twin_high -- the minimum trigger setup before the next SYNC clock edge.
These are specified for the trigger Input relative to the SYNC clock Output. The
trigger must be a minimum of two SYNC clock cycles long. The trigger timing is
specified relative to the rising edge of the SYNC clock by default, as shown in
Figure 3-10
. To guarantee proper synchronous trigger operation with arbitrary
length cables, it is possible to configure the trigger inputs to register the trigger
event with respect to the falling edge of the SYNC clock, under software control. In
this way there is always a setting for the trigger input timing which will operate
reliably for any chosen cable. The typical specifications for the trigger window
using the internal clock at 1.25 GS/s is (these values will vary at other clock
frequencies):
Twin_high > 3.4 ns
Twin_low > -2.8 ns (the trigger can occur slightly before the prior SYNC clock
edge)
Table 3-2 SYNC Clock Frequency Ranges
Frequency Range SYNC Clock Prescaler Divide Ratio
625 MHz-1.25 GHz 8
312.5 MHz-625 MHz Multi-Module Synchronization
Not Supported
156.25 MHz-312.5 MHz
100 MHz-156.25 MHz