Keysight Technologies M9537A, Руководство для стартапов

Страница: 31 / 36

Keysight M9537A AXIe Embedded Controller Startup Guide 23
Step 7: Install User Application Modules in the AXIe Chassis
AXIe chassis are shipped with filler panel modules on all except Slot 1. You may
need to remove filler panels from covered slots.
Install Application Module Drivers (if necessary)
Each installed application module typically requires device drivers and control
software. You need not install them to verify basic chassis operation. However,
you would need to install them on the M9537A controller if required by your user
application module. Consult the module provider for software requirements and
instructions.
Chassis Shutdown
As with any PC, you should not shut down Windows-based instruments by either
turning off the power via an external power source or by pulling the power plug
out from the rear panel. This could corrupt the operating system. The only
approved way to shut down the controller is to execute the Windows shutdown
process and then turn off the chassis via the chassis On/Off button.
Certain modules require bus master and/or Rear I/O capability. If
you are in doubt whether such features are required for the
module you intend to install, check your specific module and/or
system documentation to make sure that your system is provided
with an appropriate free slot in which to insert the board.
You may need to connect the embedded controller to the internet.
Locate and install the necessary drivers from the internet.
Pressing the chassis power button immediately removes power
from the controller. This may cause loss of data or damage to the
controller.