Keyscan Inc. A Member of the Kaba Group
12
Steps to Program and Install a NETCOM2P/ACU Control Board …cont’d
4.
Mount the NETCOM2P into M1 in the correct orientation as shown in Figure 6 or Figure
7.
5.
On the control board, set communication for M1 to program mode for the NETCOMP
depending on the PC109x version:
J16 – pins F and G – ON
S2 – switches 7 and 8 – ON
6.
Connect the serial programming cable from the RS-232 (COM4) terminal on the ACU
to the laptop or PC. If using the USB-SER adaptor, be sure the USB-SER adaptor has
been configured before programming.
7.
Apply power to the ACU control board.
8.
Turn on the laptop or PC connected to the ACU control board.
9.
Select start > All Programs and select Keyscan NETCOM Program Tool from the
Keyscan menu.
10.
From the Keyscan NETCOM Utility screen, click the Program NETCOM Device button.
11.
From the Select NETCOM Device Type screen, click on the Program NETCOM2 Family
of Boards button.
Continued on the next page…
