7
»
Rx Unit / IR Sensor:
»
IR Sensors can be connected directly into the Rx unit’s IR In port, without the need for an
external IR distribution block
»
IR signal on the Tip, with 5V powering of the IR sensor on the power wire .
IR Sensor / IN Pinout
Wire
Signal
Red
5V Power
White
IR Signal
Black
Ground
›
IR Out
:
»
Pass-through from signal of corresponding IR In port or bi-directional RS-232, as determined by
the position of the Control Rotary
»
Driving power: 5V with 32mA minimum current
»
Typically connected with an IR emitter
IR Emitter / OUT Pinout
Wire
Signal
Dashed/Marked
IR Signal
Solid/Black
Ground
IR Cabling
Your KD-X222PO includes an IR Sensor and an IR Emitter.
Signal acceptance:
The IR Sensor receives signals from a 90° angle at up to 30 ft . away . It accepts a
maximum IR burst frequency of 55kHz .
Only
the included IR sensors are compatible with the KD-X222PO . Third-party IR Sensors may not be
compatible .
The included IR Sensor.
Connects to the IR In port on the Rx unit.
The included blinking-type IR Emitter.
Connects to the IR Out port.
