KD-MSW4x2Pro Operating Instructions
Page 22
KD-MSW4x2Pro Operating Instructions
Page 2
Applying Power
Now that the A/V input and output interfaces are completed, it is recommended to double check all
cables and connections before applying power.
To test connections before routing or hiding any wires behind walls or ceilings, use a reliable source
(like a DVD player) and display that is known to be functioning properly.
Once all the connections have been verified, plug the connector of the Power Supply into the
power supply input jack on the rear panel of the KD-MSW4x2Pro unit.
Next, plug the external Power Supply provided with the unit into an
appropriate wall outlet or source of AC power. The external power
supply is rated: + 6V DC @ 5 Amps, 110-240 VAC, 50-60 Hz. For
added safety and protection it is recommended to use a good
quality surge protector.
The KD-MSW4x2Pro unit has no physical On/Off switch,
except on the provided IR remote control.
IR Extender
A rear-panel IR sensor is provided, ideal to use with an IR Extender,
like one provided by Xantech. The rear panel IR sensor also supports
the IR remote control provided with the KD-MSW4x2Pro unit.
Wired IR
A rear-panel wired IR serial connector is provided for use with an IR Extender, like one
provided by Xantech. Connect the wired IR Extender to the 3.5 mm jack on the rear panel
of the KD-MSW4x2Pro unit.
Mount the IR extender on the rear panel of the KD-MSW4x2Pro unit, or connect the wired serial connector cable to
the wired IR connector jack on the rear panel.
CAuTIon: no other power supply adapter can be used
with the KD-MSW4x2Pro unit. use only the Power Supply
provided in the carton! using a power supply other than
the one provided by Key Digital
™
with the unit VoIDS THE
WARRAnTY, may cause damage to the unit and associated
equipment, and is a potential safety hazard.
Always test all connections and final operation first, before sealing cables behind
walls or completing difficult wire routings.
Carefully insert the Power Supply adapter plug here
Then press 1, 2, 3, or 4 to
direct the respective source
input device to that output
Device Select
Analog Audio Volume
Control / AV Mute & Unmute
Output Select
* For stand-alone
single-unit applications,
Unit Addressing is
Not Required
1.
FIRST SELECT
OUTPUT 1 OR 2
2.
THEN DIRECT INPUT
1, 2, 3, OR 4 TO THAT
SELECTED OUTPUT
First press either the
“Output 1” button to
select output 1, or the
“Output 2” button to
select output 2
ON
Output Select
Video & Audio Mute
& Restore Keys
OFF
Numeric
Keypad
Increase / AV Mute
Decrease / AV Unmute
Command Keys
Not Used
2.
1.
MSW4x2Pro_Manual.indd 22-23
8/23/06 4:10:49 PM