Key Automation TELESCOPIC LEVANTE, Инструкции и предупреждения по установке и использованию

Страница: 49 / 156

49
EN
ATTENTION !
The maximum distance between two successive fixing screws
must not exceed 500 mm.
Once all holes have been drilled, thoroughly clean away any
shavings and aluminium residues from the beam and sliding track
housing.
For screws at the ends, however, it is advisable not to exceed a
distance of 200 mm from the end edge of the beam.
500 max
200 max
200 max
To secure the beam, use screws appropriate to the type of support
present with a diameter of not less than 6 mm and a head height
of not more than 6.5 mm.
Telescopic beam: fasten the track to the beam using the limit
switches, positioning them temporarily in a section where the slow
panel runners do not slide. The exact position must then be checked
once the panels are mounted, before tightening the limit switch
screws permanently.
Front beam: fasten the track to the beam using the limit switches,
temporarily positioning them at the ends of the track, slightly tightening
the screw in the figure in order to lock possible movements of the
block. The exact position must then be checked once the panels
are mounted, before tightening the limit switch screws permanently.
5.3 - Inserting the track on the beam
Insert the track and the anti-vibration seal in the seat provided on
the beam as shown in the image below. Make sure the seat is
clean and free from shavings.
N.B. Position the track 10 mm away from the end edge of the beam
as shown in the figure.
10 mm