15
K-2500™ BREWER
Regular cleaning keeps your brewer running smoothly.
Always be sure to
turn off and unplug your brewer before cleaning.
CAUTION:
Parts are not dishwasher safe.
Brewer Exterior
Keep your Keurig® brewer looking its best by cleaning the exterior from time
to time. Just clean with a paper towel and a non-vinegar glass cleaner.
Never immerse the brewer in water or other liquids.
Water Reservoir & Reservoir Lid
The water reservoir lid and water reservoir
should be cleaned periodically with a damp,
soapy, non-abrasive cloth. Rinse the reservoir
thoroughly after cleaning. This will ensure
that no cleaning solution remains in the area
as it may contaminate the water supply.
After rinsing, fill the reservoir with clean
water and return it to the brewer.
Do not dry the inside of the water reservoir
with a cloth as lint may remain. The water
reservoir lid and water reservoir should not
be put into the dishwasher.
Drip Tray
The drip tray can hold up to 10 ounces of
overflow and should be emptied and
cleaned occasionally.
NOTE:
The drip tray and plate are not
dishwasher safe.
To remove, slide it toward you, keeping it level
to avoid spilling. Clean with a damp, soapy,
lint-free, non-abrasive cloth.
K-Cup
®
Pod Holder
Lift the lid handle to access the K-Cup® pod
holder. To remove the K-Cup® pod holder from
the brewer, pull forward on the back of the
K-Cup® pod holder to release. Then, lift it up to
remove. After cleaning, align the K-Cup® pod
holder with the opening, using the two front
ribs as a guide, and press it down to snap it
into place.
CAUTION:
There are sharp needles that puncture the K-Cup® pod above the
K-Cup® pod holder and in the bottom of the K-Cup® pod holder. To avoid risk
of injury, do not put your fingers in the K-Cup® pod holder.
NOTE:
Used K-Cup® pod should be removed from the K-Cup® pod holder after
brewing, or as part of the daily cleaning routine.
Funnel
The funnel can be removed from the K-Cup®
pod holder for cleaning by twisting it until it
pops off. To replace it, orient the snaps to the
indents and just snap it back onto the K-Cup®
pod holder.
Exit Needle
The exit needle is
located on the inside bottom of the
K-Cup® pod holder.
To clean the needle:
Remove the pod holder
assembly and detach the funnel. Then, locate
the exit needle and insert a straightened paper
clip into the needle hole to loosen any coffee
grounds.
BREWER CARE
Continued
General Cleaning & Care
