Additional Operations
1. Re-aiming the optic
a. Remove the trim by pulling the trim directly down from the housing.
b. Unlock the emitter chassis: reach into the D3’s housing and unlock tilt lock and rotation lock levers
(both colored red) (see
fig. 14
).
c. Use the degree indicators to determine degree of rotation (square trim only) and tilt (see
fig. 15
).
Rotation Lock and Release
Locked
Unlocked
Tilt Lock and Release
Locked
Unlocked
Tilt and Rotation Angle Indication
Tilt
Rotation (Square Trim Only)
Tilt and Rotation Angle Indication
Tilt
Rotation (Square Trim Only)
fig. 13
fig. 14
fig. 15
2. Adjusting optic depth
a. Remove the trim by pulling the trim directly down from the housing.
b. To set optic at the deep regress position push optic directly up. Light engine will magnetically
lock into place (see
fig. 16
).
c. To set optic at the low regress position pull optic directly down. Light engine will magnetically
lock into place (see
fig. 17
).
Emitter Regress Depth Adjust
To Raise: Push
To Lower: Pull
fig. 16
fig. 17
16 |
D3
INSTALLATION GUIDE
P/N 3662360 Rev C
© 2019-2020 Ketra, Inc. All rights reserved.
