Kessel 917821, Инструкции по установке, эксплуатации и обслуживанию

Страница: 45 / 192

45
3. Installation and Assembly
Ill. shows an underground fuel separator size NS 6 to NS 15
During the installation of the underground fuel separator, a DN 40 (OD 50mm) conduit pipe should
be laid two the separator dome that will contain the SonicControl sensor. In the dome area of the
separator tank (as seen in the above ill.) a 60mm hole should be drilled out of the tank using a hole
saw. The control unit and the separator should be located as close to each other as possible. The
conduit pipe should be laid with no bends over 45 degree (maximum fitting bend should be 45
degrees). The conduit pipe should be installed with a constant slope toward the separator so that
any condense water will flow back into the separator and not toward the control unit or pond in
the conduit pipe. In the case that the conduit may need to be extended at a later date or the sensor
cable needs to be replaced, a string can by laid in the conduit pipe to aid running new cables. The
SonicControl cable may be extended to a total length of 60 meters. The cable screw must be tightly
fastened before running the SonicControl cable back toward the control unit. Finally secure tightly
the black plastic conduit pipe cover. If a back up occurs inside the separator the SonicControl
sensor must be inspected and cleaned if necessary.
inside outside
Order-Nr. 917822
Ill. shows an underground fuel separator size NS 3 to NS 6