Kessel 917821, Инструкции по установке, эксплуатации и обслуживанию

Страница: 42 / 192

42
Article Number of oil or coalescence separator Sludge Oil / Fuel
1) % full Measured layer Disposal 2) % full Measured layer Disposal
thickness in mm volume in liters thickness in mm volume in liters
99703.04B 50 400 550 100 235 200
99703.04D 40 320 369 80 188 160
30 240 305 60 141 120 980
20 160 241 40 94 80
10 80 177 20 47 40
99703.10B 50 800 1050 100 235 200
99703.10D 40 640 815 80 188 160
30 480 587 60 141 120 1480
20 320 369 40 94 80
10 160 241 20 47 40
99706.10B 50 400 550 100 235 200
99706.10D 40 320 369 80 188 160
30 240 305 60 141 120 940
20 160 241 40 94 80
10 80 177 20 47 40
1) The separator contents should be emptied when the sludge layer is 50% full
2) The separator contents should be emptied when the oil / fuel layer is 80% full – not disposing at this stage would exceed the oil / fuel storage capacity of the separator
.
3. Installation and Assembly
Distance
greens mark
to Container
ground
Note:
For more articles please contact the KESSEL customer service. After installation completely fill the separator with water, check height and
correct if necessary! Completely filled separator must perform the „manual mode“ (2.1) SonicControl „0 cm“ show. Should be no mechanical
correction possible change in „Parameters -> level adjustment“(3.1.7) to perform.
The parameters are password protected - please contact the KESSEL customer service.
Adjustment of the SonicControl sensor can be handled with two different methods: By measuring with a ruler (separator must be empty in
order to use this method) or the sensor is adjusted using the colored marks. The separator must be filled with clean water in order to use this
method (must not be filled with oil or fuel).