43
A
B
D
C
3. Installation and Assembly
3.3 Installation of sensor holding bracket.
1. Open the cover on the oil or coalescence se-
parator (use caution removing the heavy cast
iron or concrete covers – a lifting aid system is
recommended.
2. Using the including drilling template bracket,
mark on the upper section of the separator the
two holes located on the bracket. Drill two 6mm
holes in the location of the two marks.
3. Screw two included screws into the two holes
in the upper section until there is a distance of
25mm between screw head and upper section
wall.
4. In the case that the separator has installed
deeper than the standard installation depths,
use the supplied pipe (D) as an extension.
5. Now clip the SonicControl sensor in the holding
clips (C) and then secure the bracket (B) by han-
ging it onto the two screws. Now fully tighten
the two screws so that the bracket is securely
fixed to the separator’s upper section
6. Now adjust the SonicControl sensor to the green
mark on the sensor with the full water level (for
information on the sensor green mark, please
see the next page.
Caution:
The SonicControl’s cable should not be in the way or above any of the
sensor probes (in the water).
Caution
do not drill
through
sealing
gasket!
Содержание 917821
