1.5 Correction of intermediate position
The taught-in intermediate position can be corrected within a range of /-3 cm.
The time window for setting is 3 minutes after power has been restored, or after deleting the values
using the sensor switch.
This value can also be overwritten as many times as required within the time window.
2 Deleting all settings (RESET) via reed contact
Here, all settings are reset to the factory settings. When doing so, the endpoints, the pulling forces and
also the intermediate positions and their correction values will be deleted. Please refer to Point 1 for
teaching in new values.
3 Deleting all settings (RESET) except intermediate positions
This is the normal deletion procedure which can and should be carried out by end users when
required.
During this deletion procedure, the intermediate position which was set at the factory is retained.
If you press the sensor button (6.1.) for 30 seconds when the motor is at a standstill (outside travel
movement) the deletion process will be carried out. After the process, the drive gives
acknowledgement by starting up briefly.
4 Normal operation without intermediate position
Press the sensor button briefly. The drive reacts with the following sequence: UP, STOP, DOWN,
STOP, UP etc. Starting up the motor always takes place using a soft start. The suspension comes to a
standstill at the programmed end position.
5 Operating function with intermediate position
Press the sensor button briefly: Start/stop "as previously". In the UP direction, the drive stops at the
programmed intermediate position.
In the DOWN position the drive runs through without stopping at intermediate positions.
If the drive stops at one of the intermediate positions in the UP direction, the following functions are
available.
Press the sensor switch briefly and release it within one second: drive will run in the UP direction until
the top end position. Press the sensor switch for more than 1 second: drive will run in the DOWN
direction until the end position.
.
'
