21
Assembly
8
Assembly
8.1 Assembly of the attachment
•
To mount an attachment, the attachment and attachment tube on the drive unit must be
clean and well-lubricated (see Figure 8.1).
•
The coupling of the attachment and the receiving tube of the drive unit must be at the
same height to allow them to be pushed together. For this purpose, parking supports are
available on some attachments, where the appropriate height can be adjusted.
•
When assembling, it is important to note that the coupling driver (red plastic star) is
located in one of the two coupling halves.
•
Pull up on the locking lever and lift up the locking lever.
•
If the attachment of the attachment can not be pushed completely into the pick-up tube,
then the teeth of the two coupling halves may be opposite each other. By switching on
the power take-off and by slowly pulling on the starter cable of the engine, the drive shaft
continues to rotate, allowing the further drive in.
•
Lower the locking lever again and check that the locking pin is fully engaged.
Figure 8.1
Coupling
driver
Grease nipple
