Kerning THM GOTHIC, Руководство по эксплуатации

Страница: 36 / 50

36
3.15 Gothic Hammer Flight Time Routine
A. Remove the paper from the printer, leaving only the ribbon installed.
B. Press ENTER to select the routine.
C. HAMR 1 is viewed in the display.
D. To modify the column number use the NEXT key to increment by one or the
Up/Down Arrow keys to increment/decrement by 10.
E. Press the ENTER key to fire the selected hammer. HAMR # XXXX is viewed in
the display.
F. The # is the column number and the XXXX is flight time. The acceptable time
range is 2500-2600.
G. If the flight time value displayed is outside the acceptable range, adjust the
appropriate backstop screw and continue firing the hammer until the value is set
at 2550.
H. To exit the routine press the CLEAR key.
3.16 Select Interface Routine
A. Press the ENTER key to start the routine and to display the current interface.
B. Use the NEXT key to step through the interface options: CENTR PARALLEL or
DPC PARALLEL .
C. To select an interface press the ENTER key and the display reflects the selection
with either CENT PAR or DPC PAR .
D. The routine returns to the Program Mode menu after a short pause and the display
indicates SELECT INTERFACE .
NOTE
It is recommended to initialize the printer after changing the interface
selection. In offline mode depress the RESET key and then ENTER
when <ENTER> TO RESET is viewed.