4
228-1744 REV 3
080515
KEPCO, INC.
131-38 SANFORD AVENUE
FLUSHING, NY. 11355 U.S.A.
TEL (718) 461-7000
FAX (718) 767-1102
http://www.kepcopower.com
email: [email protected]
FIGURE 3. A4A8 COMPONENT LOCATION/WIRING
5.
Install the 5-pin cable assembly (P/N 118-1265) on Transition Circuit A7A3J1 (see Figure 1) of the PCB. Route
the cables as shown by Figure 6. This cable assembly has a 5-pin connector with five (5) unterminated wires.
Determine the needed length, cut the wire and remove the insulated sleeving (approximately 0.15"), then sol-
der each wire to the indicated point of assembly A2A5 (see Figure 4 for location of wire attachment points and
Figure 6 for cable routing):
• white/yellow wire to A2A5D26 Anode
• white/blue wire to junction of A2A5R40 and J3, pin 6
• black wire to A2A5TP1
• red wire to A2A5TP7
• white wire to A2A5TP8
FIGURE 4. A2A5 COMPONENT LOCATION
