080515
228-1744 REV 3
3
KEPCO, INC.
131-38 SANFORD AVENUE
FLUSHING, NY. 11355 U.S.A.
TEL (718) 461-7000
FAX (718) 767-1102
http://www.kepcopower.com
email: [email protected]
FIGURE 2. BOP 1KW COMPONENT LOCATIONS
4.
Install the 4-pin cable assembly (P/N 118-1266) on Transition Circuit A7A3J3 of the PCB (see Figure 1). Route
the cables as shown by Figure 6. This cable has three (3) unterminated wires. Determine the needed length,
cut the wire and remove the insulated sleeving (approximately 0.15"), then solder each wire to the indicated
point (see Figure 3 for A4A8 component locations and Figure 6 for cable routing):
• red wire to A4A8D1 Cathode
• black wire to A4A8D1 Anode
• white wire to A4A8TP2
3043897
CHASSIS GROUND CONNECTION
SCREW (QTY 2), PHPH,
6-32 X 0.5 IN., ST
KEPCO P/N 101-0519
TRANSITION CIRCUIT
ASSEMBLY A7A3
A2A5 ASSEMBLY
(SEE FIGURE 4.)
A4A3 ASSEMBLY
(SEE FIGURE 3.)
A1 ASSEMBLY
(SEE FIGURE 2.)
OUTPUT MODULE
(A2) FAN
NOTE:
TO MOUNT TRANSITION
CIRCUIT ASSEMBLY A7A3
INSERT ONE SCREW IN
VENTILATION HOLE A, THE
OTHER IN HOLE B. IF THE
CHASSIS BOTTOM MUST
BE FLUSH TO A FLAT
SURFACE, THE CHASSIS
HOLES A AND B MUST BE
COUNTERSUNK.
(PARTIAL TOP VIEW)
B
(SEE NOTE.)
FAN MOUNTING
SCREW
A
(SEE NOTE.)
FRONT
PANEL
