6
228-1921
022720
KEPCO, INC.
131-38 SANFORD AVENUE
FLUSHING, NY. 11355 U.S.A.
TEL (718) 461-7000
FAX (718) 767-1102
http://www.kepcopower.com
email: [email protected]
verify the OFF indicator above the button changes to
ON (green) indicating the output is on.
4. Program the channel by entering desired output volt-
age in the
VOLTAGE
field, and current limit in the
CURRENT
field, then click
SET
. Settings that exceed
the channel’s rated voltage/current will not be
accepted.
5. From the Operate Instrument page, click the Output
ON/OFF
button at the upper right of the web page and
verify the OFF indicator above the button changes to
ON (green) indicating the output is on.
6. Verify the output of the BOP changes and the voltage
indication is the same on both web page and the BOP
front panel.
FIGURE 7. BOP 2X-DE SERIES, FRONT PANEL CONTROLS AND INDICATORS
4.2. CURRENT MODE OPERATION WITH VOLT-
AGE LIMITING.
The BOP channel may be used as a
stabilized d-c source of positive or negative current, with
output voltage limiting (for either polarity), pre-selected for
the application at hand. Always monitor the front panel
meters while adjusting output voltage/current.
1. Refer to PAR. 3.4 and connect the load to the DC
OUTPUT Terminal Block for the channel in use.
2. Perform steps 1 through 9 of the Preliminary Checkout
(see PAR. 3.2).
3. Click on the
MODE
button at the upper right side of the
Operate Instrument page until the indicator above the
MODE
button reads
CURRENT
.
4. Program the channel by entering desired output cur-
rent in the
CURRENT
field and voltage limit in the
VOLTAGE
field, then click
SET
. Settings that exceed
the channel’s rated voltage/current will not be
accepted.
5. From the Operate Instrument page, click the Output
ON/OFF
button at the upper right of the web page and
verify the OFF indicator above the button changes to
ON (green) indicating the output is on.
6. Verify the output of the BOP changes and the current
indication is as programmed on both the web page and
the BOP front panel.
Channel 1
A-C POWER
switch/circuit
breaker
Channel 1
VOLTAGE MODE
indicator (green)
or
VOLTAGE LIMIT
indicator (yellow)
Channel 1 or 2
VOLTAGE
meter (d-c Volts)
Channel 2
A-C POWER
switch/circuit
breaker
CHANNEL 1 -
CHANNEL 2
select switch
3044250
Channel 2
VOLTAGE MODE
indicator (green)
or
VOLTAGE LIMIT
indicator (yellow)
Channel 1
CURRENT MODE
indicator (green)
or
CURRENT LIMIT
indicator (yellow)
Channel 2
CURRENT MODE
indicator (green)
or
CURRENT LIMIT
indicator (yellow)
Channel 1 or 2
CURRENT
meter (d-c Amps)
