Kenwood VZ-5000, Инструкция по эксплуатации

Страница: 9 / 80

English 9
Setting the AV IN-2 Mode [AV-IN2]
Touch Setting
[
¶
AUTO] It becomes the auto video mode
setting. When the video signal input to the
AV IN2 terminal, the monitor image is
switched to the image of the device
connected to the AV IN2 terminal.
[
¶
MANUAL] It becomes the video mode setting. Operate
the V.SEL button when the image from the
device connected to AV IN2 terminal is
shown on the monitor.
Select the AV IN-2 input display
Selecting the display when this device is switched to
internal AV-IN2 terminal input source.
Each time you touch the [
2
] or [
3
] button, the
display switches as follows:
"VIDEO 2"
´
"R-CAM"
´
"OFF"
Setting the Rear view camera image:
(AV-IN2 setting during “R-CAM”)
Touch Setting
[
¶
ON] The image which appeares in the camera is
turned left-side right and displayed.
[
¶
OFF] The image which appeares in the camera is
displayed as it is.
Touch Sensor Tone [BEEP]
Setting the operation check sound (beep sound)
ON/OFF.
Touch Setting
[
¶
ON] Touch sensor tone is turned on.
[
¶
OFF] Touch sensor tone is turned off.
Switching the Setup Screen - 2
Touch the [
3
] button.
Exit the System Setup-1 Screen
Touch the [RETURN] button.
Return to the setup menu screen.
Setting the NAV Mode [NAV]
Touch Setting
[
¶
RGB] It becomes the RGB mode setting. Operate
the V.SEL button when the image from the
navigation unit connected to I/F terminal is
shown on the monitor.
[
¶
AV-IN1] It becomes the AV-IN1 mode setting.
Operate the V.SEL button when the image
from the navigation unit connected to AV
IN1 terminal is shown on the monitor.
[
¶
OFF] It becomes the OFF mode setting.Use this
setting when there’s nothing connected to
the I/F terminal.
Setting the AV IN-1 Mode [AV-IN1]
Touch Setting
[
¶
VIDEO 1] It becomes the video mode setting.Operate
the V.SEL button when the image from
the device connected to AV IN1 terminal is
shown on the monitor.
[
¶
NAV] It becomes the navigation mode setting.
Operate the V.SEL button when the image
from the navigation unit connected to AV
IN1 terminal is shown on the monitor.
[
¶
OFF] It becomes the OFF mode setting.Use this
setting when there’s nothing connected to
the AV IN1 terminal.
System Setup Screen-1
English